NK Technologies' ADC series signal converters use sensor outputs (4-20 mA, 0-5 and 0-10 VDC) and convert these to digital RS485 outputs. The CTC series accept either 5 A secondary current from current transformers or 0.333 VAC secondary voltage from our ProteCT series sensors and convert them to 4-20 mA looppowered output for use with PLCs, panel meters or data loggers.
The CTC Series AC Signal Converters allow you to use an existing standard 5 A secondary or low-voltage ProteCT series current transformer over a conductor to produce an industry standard 4-20 mA two-wire, loop-powered signal.
The signal is proportional to the current in the primary circuit.
The CTC series snaps onto a standard DIN rail.
The output is connected to the load and a 24 VDC source and the current transformer is connected.
If you are looking for NK Technologies Signal Converters, please call us on (800) 894 - 0412 or email us at firstname.lastname@example.org we will do our best to help you find the NK CTC Series transmitters that you are looking for at the most competitive prices possible. If you are searching for Neilsen Kuljian ADC Series analog to digital converter technical information (data-sheets) please use the datasheets or product selection guide page links.
The ADC Series connects up to eight 4-20 mA looppowered analog sensors, or up to eight separately powered 4-20 mA output sensors, or up to four of each.
This will produce a digital signal representing 0-100% of each sensor output. It is the perfect solution for photovoltaic power production system monitoring.
The ADC converter allows for individually-ranged devices to interface with the industry standard Modbus RTU serial protocol. The device can accept analog signals from current, voltage or temperature sensors, allowing the installer great versatility and higher accuracy. It was designed and built to meet the standards of reliability and easy of use that NK Technologies is know for.
DIN Kit or DIN-2 Adapter Kit
DIN Rail Kits provide a convenient method to facilitate the mounting of the AGL, VTR, APT & APMR series of NK Technologies' sensors.
The kits can also be used to mount other products to a panel as needed.
Our industrial factory automation supplies distributors warehouse in Boise, Idaho stocks some NK Technologies products enabling us to further assist you in finding the correct NK CTC signal converter for your application in the USA, Canada and Mexico. Whether we have NK ADC signal converter in stock in Boise, Idaho or need to ship direct from NK Technologies to any USA cities; Clearwater Tech can get Neilsen Kuljian CTC current transformer to you fast and save money! It will be very helpful if you have the NK ADC analog to digital converter part numbers ready, then our sales representatives can provide you with a pricing and availability quote for NK CTC series transmitters that you are looking for in seconds. If you do not have the part numbers for NK ADC series signal converters, our application engineers will be able to help you figure out the part numbers and get the price quote to you as soon as possible.
RS U-D8 Analog to Digital converters digitize analogue voltage signals and have 8-bit accuracy. All modules are equipped with a hold function, so that the momentary output value is maintained even during a change to the input value. D/A converters convert digital signals into analogue signals. They are used for converting 8-bit digital signals into standardised analogue current and voltage signals.
When an Abnormality, such as loss of suction is detected, the PumpSaver Plus deactivates its output relay and directly disconnects the pump motor. The PumpSaver Plus then begins its user-selectable "Restart Delay" (dry-well recovery) timer. When the timer expires or power is removed and reapplied, the PumpSaver Plus reactivates its output relay and allows the pump to turn back on. The Model 235P communicates with