SymCom

Home   >   Products   >   SymCom   >   Intrinsically Safe Switches

(800) 894-0412       (208) 368-0415 (Fax)
info@clrwtr.com

SymCom Model ISS-100 isolated switch is UL 913 listed as an associated apparatus for interfacing between hazardous and non-hazardous areas. The ISS-100 must be installed in a non-hazardous area.

If you are looking for SymCom Intrinsically Safe Relays, please call us on (800) 894 - 0412 or email us at info@clrwtr.com we will do our best to help you find the SymCom Intrinsically Safe Switches that you are looking for at the lowest prices possible. If you are searching for SymCom Intrinsically Safe Controllers technical information (data-sheets) please use the SymCom Datasheets OR Product Selection Guide page links.

SymCom's ISS-102A-LC (Latching Controller) is a dual-input, single output (form A), pump controller with latching/differential logic. Both input channels are compatible with switches (float, pressure, etc.) and resistive probes (fixed 100kO threshold). Each input channel is "active" when the corresponding switch is closed (or low resistance is detected, if using probes). When the LAG input (CH2) is activated, the output contact closes. Following latching/differential logic, the output contact remains closed until both the LEAD (CH1) and LAG (CH2) inputs are deactivated. The green RUN LED illuminates when the output relay is energized.

SymCom Model ISS-101 is a plug-in style isolated Switch, is UL 913 listed as an associated apparatus for interfacing between hazardous and non-hazardous areas. The ISS-101 must be installed in a non-hazardous area.

SymCom ISS-105 IS Super Cell is a "smart" five-channel intrinsically safe relay and pump controller. The IS Super Cell can be configured for a wide variety of applications including alternating or non-alternating duplex, duplex separate pump stop (SPS), triplex, and quadplex applications. It can be set up for pump up or pump down applications or can be used as a five-channel relay.

The IS Super Cell has a long list of features that are needed for multiple pump applications. The IS Super Cell can indicate low, high and out-of-sequence alarms. If an out-of-sequence alarm occurs, the skipped pump(s) will be started as intended. SymCom MotorSaver Model ISS-105 can be set up to do non-alternating control, alternating control and alternating control with one non-alternating pump. The non-alternating pump is intended for use with an emergency or jockey pump. The IS Super Cell can start an emergency pump once every 50 cycles to keep it working freely. Using the Built-In DIP Switches, individual pumps can be disabled when taken out of service for repair or maintenance.

SymCom's ISS-102AA-DCS is a dual-channel switch with two form-A output relays. The input resistance threshold is fixed at 100kO. Each output contact closes upon closure of its associated input switch (input resistance <100kO). Resistance probes or switches can be used on the inputs. The ISS-102AA-DCS has a 0.5-second debounce time delay - the output contact will not change states until a condition exists for 0.5 second - to prevent nuisance actuation and rapid cycling. Green LEDs illuminate on the ISS-102AA-DCS when the associated output relay is energized.

SymCom's ISS-102ACI-MC (Multi-function Controller) is user-configurable as a single or dual-channel switch, or pump-up/pump-down controller. The intrinsically-safe inputs are compatible with normally open (N.O.) or normally closed (N.C.) switches, as well as resistive probes. Input logic can be either direct or inverted. Input debouncing is selectable to either 0.5 or 2 seconds. For pumping applications, differential/latching logic can be selected. Green LEDs illuminate on the ISS-102AA-DCS when the associated output relay is energized.

The ISS-105-ISO relays are 120VAC powered isolated switches suitable for transferring switch states from hazardous locations to non-hazardous locations. Each input controls the corresponding output. The green LEDs illuminate when the corresponding input is closed. The red LEDs illuminate when the corresponding relay is energized.

The ISS-105-ISO-F relay, powered by 120VAC, is an isolated switch suitable for applications with switch inputs in a hazardous location. In a powered state, the ISS-105-ISO-F will actuate each output relay within .75 second of the corresponding input switch closing/opening (dependent on positive/negative logic mode). Each red LED illuminates when the corresponding output relay is energized. Each green LED illuminates when the corresponding input is closed.

Our SymCom distributors warehouse in Boise, Idaho USA stocks some SymCom MotorSaver products (SymCom Intrinsically Safe Isolated Switches ISS-100 ISS-101 Plug-In ISS-105 Pump Relays Dual Channel Latching Controllers Distributors) enabling us to further assist you in finding the correct SymCom Isolated Switches in the USA (Alabama Alaska Arizona Arkansas California Colorado Connecticut Delaware Florida Georgia Hawaii Idaho Illinois Indiana Iowa Kansas Kentucky Louisiana Maine Maryland Massachusetts Michigan Minnesota Mississippi Missouri Montana Nebraska Nevada New Hampshire New Jersey New Mexico New York North Carolina North Dakota Ohio Oklahoma Oregon Pennsylvania Rhode Island South Carolina South Dakota Tennessee Texas Utah Vermont Virginia Washington Washington D.C. West Virginia Wisconsin Wyoming), Canada and Mexico.

Whether we have SymCom Latching Controllers in stock in Boise, Idaho USA or need to ship direct from SymCom to any USA cities (New York Los Angeles Chicago Houston Philadelphia Phoenix San Diego Dallas San Antonio Detroit San Jose Indianapolis San Francisco Columbus Austin Baltimore Milwaukee Boston Washington El Paso Seattle Denver Charlotte Fort Worth Portland Oklahoma City Tucson New Orleans Las Vegas Cleaveland Long Beach Alburquerque Kansas City Fresno Virginia Beach Atlanta Sacramento Oakland Mesa Tulsa Omaha Minneapolis Honolulu Colorado Springs St. Louis Whichita Santa Ana Pittsburgh Arlington Cincinnati Anaheim Toledo Buffalo St. Paul Corpus Christi Aurora Raleigh Newark Lexington Fayette Anchorage Louisville Riverside Bakersfield Stockton Birmingham Jersey City Norfolk Baton Rouge Hialeah Lincoln Greensboro Plano Rochester Glendale Akron Garland Madison Fort Wayne Fremont Scottsdale Montgomery Shreveport Lubbock Chesapeake Mobile Des Moines Grand Rapids Richmand Yonkers Spokane Augusta Rhichmand Glendale Tacoma Irving Huntington Beach Arlington Modesto Durham Boise Winston Salem); www.clrwtr.com can get SymCom Intrinsically Safe Plug-In Isolated Switches to you fast and save you some money!

It will be very helpful if you have the SymCom Safety Relays & Pump Controllers part numbers ready, then our sales representatives can provide you with a pricing and availability quote for SymCom Intrinsically Safe Dual Channel Switches that you are looking for in seconds. If you do not have the part numbers for SymCom Intrinsically Safe Multi Channel Controllers, our application engineers will be able to help you figure out the part numbers and get the price quote to you as soon as possible.