(800) 894-0412       (208) 368-0415 (Fax)
info@clrwtr.com

TURCK FCMI flow meters have an accuracy rating of 2 percent of the measured value. Unlike paddle wheel or vortex flow meters, FCMI flow meters do not obstruct the flow of the media to obtain a measurement.

• Flow meter for a broad range of applications
• Measuring accuracy: 2% of the measured value
• Unobstructed pipe diameter without pressure loss
• Minimum conductivity: 10 µS/cm For Example: water =15µS/cm
• Push Button Programming (access code-protected)
• Device available with 1 switching output and linear 4-20 mA analog output
• 3/8" fitting process connection

If you are looking for TURCK Flow Sensors, please call us on (800) 894 - 0412 or email us at info@clrwtr.com we will do our best to help you find the TURCK Flow Monitors that you are looking for at competitive prices. If you are searching for TURCK Flow Meters technical information (data-sheets) please use the TURCK Datasheets OR Product Selection Guide page links.

With TURCK FCS series self-contained devices, the flow monitor and the signal processor are incorporated in one compact housing. This device is ideal for monitoring liquid flow speed in the 2 to 295 ft/min range.

• Self-contained compact housing for monitor and signal processor
• Pressure resistance up to 870 psi
• Enclosure meets IP 67, NEMA 1, 3, 4, 4x, 12, 13
• Maximum setpoint accuracy during changes in flow temperature
• Simple adjustment by means of potentiometer
• Relay output for 250 VAC/4 A, N.O.

TURCK insertion style flow monitors are used in applications where it is necessary to monitor liquid flows. These devices are designed for direct installation into the pipeline by means of a pipe-tee or a welded pipe socket. The flow monitors are suitable for use in a 1/2 inch pipe diameter or larger.

• Remote switch to be used with separate signal processor
• Dynamic pressure resistance: - Standard: up to 1450 psi - Extended: up to 7250 psi
• Temperature range: - Standard: 13° to 176°F - Extended: 32° to 212°F
• Housing material: 316TI stainless steel and Teflon

TURCK sanitary style flow monitors are well suited for the dairy, food and beverage industries. The non-contaminating and non-corrosive design is in accordance with the ASME Food, Drug & Beverage Equipment Sanitary Standard #ANSI/ASME F2.1-1982.

• Flow monitors for dairy applications in the food and beverage industry
• Dynamic pressure resistance up to 145 psi
• 316L stainless steel housing

These flow monitors are ideal for applications involving very low flow rates of liquids or gasses. The fast response time allows these flow monitors to be used in applications where other flow switches can't perform.

• Ideal for very low flow rates
• For use with liquids or gases
• Stainless steel wetted parts
• Connects directly into the pipeline with a ¼" thread
• 4 mm or 10 mm diameter available
• Pressure resistance up to 290 psi
• IP 67 rating
• Switch-point accuracy during changes in flow temperature
• Fast response time

TURCK FCS-K20-AP8X flow monitors are self-contained devices. Monitor and signal processor are incorporated in one compact housing. They monitor nonexplosive gaseous media in a flow speed range from 0.5 to 15 m/s.

• Monitor and signal processor in one compact housing
• Protection class IP 67
• Maximum switch point accuracy during changes in flow temperature
• Simple adjustment by means of potentiometer
• Transistor output, PNP, short-circuit protected

The MK96-11-R/24VDC are single channel devices designed for use with insertion style and in-line flow monitors. All logic functions as well as the adjustments and display elements are combined in one 18 mm wide package. The devices mount on a 35 mm DIN track.

• Signal processors for insertion style and in-line flow monitors
• One normally open dry contact
• 18 mm wide terminal housing
• Finger protection according to VGB 4 and VDE 0470, Part 1
• Simple switching setpoint calibration with potentiometer
• Six LEDs to indicate flow conditions

This DC self-contained flow device has a flow monitor and signal processor incorporated into one compact housing. It is ideal for monitoring liquid flow speeds in the 2 to 295 ft/min range.

• All stainless steel housing
• DC PNP/NPN transistor output, short-circuit protected
• Flow monitor and signal processor in one compact housing
• Dynamic pressure resistance up to 870 psi
• Simple adjustment by means of potentiometer

The single channel MS96-12R signal processor is designed for use with insertion and in-line style flow monitors. In addition to monitoring flow speed, the unit will also monitor flow temperature.

• Remote signal processor for use with insertion and in-line style flow monitors
• Units available for 115 VAC or 24 VDC
• Two SPDT relay outputs for flow and temperature control
• Six LEDs for flow indication
• Wire-break monitoring
• Adjustable temperature control over -20° to +100°C (-4° to +212°F) range
• Built-in switch OFF delay, from 0 to 25 seconds

Our TURCK Flow Sensor Distributors warehouse in Boise, Idaho stocks some TURCK products (TURCK Flow Monitors Air Self Contained Remote Stainless Steel Liquid Probes Signal Processors Amplifiers Flow Meters Distributors) enabling us to further assist you in finding the correct TURCK Flow Monitors for your application in the USA (Alabama Alaska Arizona Arkansas California Colorado Connecticut Delaware Florida Georgia Hawaii Idaho Illinois Indiana Iowa Kansas Kentucky Louisiana Maine Maryland Massachusetts Michigan Minnesota Mississippi Missouri Montana Nebraska Nevada New Hampshire New Jersey New Mexico New York North Carolina North Dakota Ohio Oklahoma Oregon Pennsylvania Rhode Island South Carolina South Dakota Tennessee Texas Utah Vermont Virginia Washington Washington D.C. West Virginia Wisconsin Wyoming), Canada and Mexico.

Whether we have TURCK Flow Monitors in stock in Boise, Idaho or need to ship direct from Turck to any USA cities (New York Los Angeles Chicago Houston Philadelphia Phoenix San Diego Dallas San Antonio Detroit San Jose Indianapolis San Francisco Columbus Austin Baltimore Milwaukee Boston Washington El Paso Seattle Denver Charlotte Fort Worth Portland Oklahoma City Tucson New Orleans Las Vegas Cleveland Long Beach Albuquerque Kansas City Fresno Virginia Beach Atlanta Sacramento Oakland Mesa Tulsa Omaha Minneapolis Honolulu Colorado Springs St. Louis Wichita Santa Ana Pittsburgh Arlington Cincinnati Anaheim Toledo Buffalo St. Paul Corpus Christi Aurora Raleigh Newark Lexington Fayette Anchorage Louisville Riverside Bakersfield Stockton Birmingham Jersey City Norfolk Baton Rouge Hialeah Lincoln Greensboro Plano Rochester Glendale Akron Garland Madison Fort Wayne Fremont Scottsdale Montgomery Shreveport Lubbock Chesapeake Mobile Des Moines Grand Rapids Richmond Yonkers Spokane Augusta Glendale Tacoma Irving Huntington Beach Arlington Modesto Durham Boise Winston Salem); www.clrwtr.com can get TURCK Flow Meters to you fast and save you money!

It will be very helpful if you have the TURCK Flow Monitors part numbers ready, then our sales representatives can provide you with a pricing and availability quote for TURCK Flow Sensors that you are looking for in seconds. If you do not have the part numbers for TURCK Flow Meters, our application engineers will be able to help you figure out the part numbers and get the price quote to you as soon as possible.