fuji faq

How Do I Set The Operation Command Settings?

Fuji 3/19/2018
How Do I Set The Operation Command Settings?The operation command setting is F02 (Operation / operation). Please set the desired setting method. * Factory shipping setting value is F02 = 2 (Touch panel operation (normal rotation)).
0: Touch panel operation (rotation direction input: terminal block)
RUN Key / STOP - You can operate and stop by key. Specify the direction of rotation with the digital input terminal function FWD or REV.

1: External signal (digital input)
It is possible to operate / stop with the digital input terminal function "FWD", "REV".

2: Touch panel operation (normal rotation)
RUN Key / STOP - You can operate and stop by key. Rotational direction command is unnecessary. However, with forward rotation only, reverse rotation operation is not possible.

3: Touch panel operation (reverse rotation)
RUN Key / STOP - You can operate and stop by key. Rotational direction command is unnecessary. However, forward running operation can not be performed only with reverse rotation operation.

How Do I Set The Operation Command Settings?

Setting Method


One Point Advice

F02 cannot change
1. Change to the state where terminal [FWD] or terminal [REV] and terminal [CM] are not short-circuited.
2. Make sure that the data protection setting is not on. F00 (Data protection) 0. Please set it.